AVR45 om (G).Eng,Fr 4/16/99 11:41 AM Page 31
Programming the Remote
31
After following these steps, each time1. Press the Device Control SelectorRe-Assigning Device Control
you press the Power button c, thebfor the unit you wish to have asso-Selectors
remote will send the Power On/Offciated with the volume control and the
command each time the PowerMutebutton dat the same timeAlthough each of the seven Device
button is pressed.until the red light illuminates underControl Selectorbsis normally
the Device Control Selector.assigned to the category of product shown
To remove a macro program, follow stepson the remote, it is possible to re-assign
1, 2 and 4 above, but do not follow step2. Press the Volume Upbutton z.one of these buttons to operate a second
three. For example, to erase the macrodevice of another type. For example, if you
just entered, press the Device Control3. Press either the AVRa or the have two VCRs, but no satellite receiver,
Selectorband the MutebuttonTV Device Control Selectoryou may program the OSAT� button to
dat the same time until the red lightb, depending on which systemOsoperate a second VCR. Before following
under the Device Control Selector turnsvolume control you wish to havethe normal programming steps for either
on. Press the Power button c, andattached for the punch-through mode.Three-Digit entry or Auto Search code
then press the Sleepbutton `. TheNote that the red light under theentry, you must first re-assign the button
red light under the Device ControlDevice Control Selectorwill blinkwith the following steps:
Selectorwill blink twice to confirm thetwice and then go out to confirm the
data entry and then turn off.data entry.1. Press the Device Control Selector
byou wish to re-assign and the
Volume Punch-ThroughExample: To have the AVROs vol-Mutebutton dat the same time
ume control be activated evenuntil the red light illuminates under
The AVR45Os remote may be programmedthough the remote is set to controlthe Device Control Selector.
to operate the Volume Controlzthe TV, first press the TV Device
from either the TV or the AVR to operate inControl Selectorb, and the2. Press the Device Control Selector
conjunction with any of the eight devicesMutebutton dat the same time.bfor the function you wish to
controlled by the remote. For example,Next, press the Volume Upbuttonprogram into the re-assigned button.
since the AVR45 will likely be used as thez, followed by the AVR Device
sound system for TV viewing, you mayControl Selectora.3. Enter the three-digit code for the spe-
wish to have the AVROs volume activatedcific model you wish the re-assigned
although the remote is set to run the TV.NOTE: Should you wish to return thebutton to operate.
Either the AVR or TV volume control mayremote to the original configuration after
be associated with any of the remoteOsentering a Volume Punch-Through, you4. Press the same Device Control
devices. To program the remote for Volumewill need to repeat the steps shown above.Selectorpressed in Step 1 again to
Punch-Through, follow these steps:However, press the sameDevice Controlstore the selection.
Selector in steps one and three.
Example: To use the SAT button to
operate a second VCR, first press the
SAT Device Control Selector
b, and the Mutebutton dat
the same time until the red light
glows under the SAT button. Press
the VCR button, followed by the
three-digit code for the specific
model you wish to control. Finally,
press the SAT button again. |
ACEC
